router-bits.jpg bit-drilling-masonry.jpg circle-cutter-leash.jpg biter-duct.jpg


Saw-Dog-Blades
Saw-Dog-detail
Saw Dog Blades

Perfect for cutting multiple materials at one time!

These carbide-tipped blades are loaded with teeth for finish cuts you don't have to sand! True to the Bad Dog mantra, Saw Dog Blades cut a variety of materials like solid surface materials, carbon fiber, melamine, laminate, cement siding (but NOT masonry) and non-ferrous metals. Heck, they even cut wood. And Saw Dog Blades are perfect for cutting multiple materials at one time.

They might not have rippling abs or an hourglass figure, but Saw Dog Blades do have great bodies. That's the circular disc — or plate — that makes up the main component of a saw blade. A proprietary mix of metals and low tolerances make for a true running blade.

At the outer diameter of the plate are the teeth. This is where all the work gets done. Saw Dog Blades have loads of teeth made from T.C.T. (tungsten carbide and titanium), a super-hard alloy made for cutting other really hard materials. As you may have noticed, the teeth are set at angles to one another. There's actually a method to the madness of that left, right, and center mounting pattern — it prevents kick-back. And that makes for safer cutting.

The third major part of a saw blade is the arbor hole. Sure, it's just a hole, but that's where the saw blade attaches to the saw, making it a critical piece. A good fit is crucial for maximum safety and best performance. Never install a saw blade that does not fit correctly on the tool on to which you are mounting it!

Available in 7-1/4", 10", and 12" diameters, whether your project calls for a table saw, a miter saw, or a circular saw, there's a Bad Dog Saw Dog Blade to fit that tool.




Lifetime Satisfaction Guarantee


Bad Dog Saw Dog Blades are covered by a Lifetime Satisfaction Guarantee.

We will repair or replace any Saw Dog Bits that becomes dull or damaged.

Return the blade(s) along with $1 USD per inch for S&H. For example, a 10" Saw Dog Blade would have a S&H charge of $10.

Please note: Weight constraints limit replacement of Saw Blade to mail only.

Sorry, they cannot be replaced at trade shows.


Phone: 1 800 252 1330  |  Fax: 401 253 1377